Windows 7 test mode

Initially, the “seven” is configured in such a way that it does not allow the installation of unsigned drivers. This is a special system protection. It is removed if the test mode Win 7 is activated.

Test Setup

The Windows test mode 7 may be activated as a result of the installation of any software in which the corresponding script is built into the installer. An ordinary user will easily notice a change in the system by inscription from the bottom of the screen. It is small in size, but still seriously distracting.

Test Notice on Windows 7

In this case, deactivation of this function will be required. But there are also reverse situations, for example, when you need to put custom software. And this is impossible to do without activating work with unsigned drivers.

Shutdown

Everyone who is hindered by the inscription on the desktop will be interested in a way to turn off the test mode in Windows 7. This is done from the Command Line. To run it, open “Start”, in the complete list find the section “Standard”, there is the right point. Press PCM on it and then “Start from …”.

Running the Command Line with the administrative privileges from the Start menu

In a text box with a flashing cursor, write a request bcdedit.exe -set loadoptions ENABLE_INTEGRITY_CHECKS, and then press Enter, after which – bcdedit.exe -set TESTSIGNING OFF

Disabling Test Mode in Command Line

Note: you cannot insert the text, you need to manually drive it from the keyboard.It remains only to restart the system. Important: if you open the command line without administrator rights, then the command will be accompanied by a message “Affordable”. This suggests that you missed the item “Start from …”.

Activation

Activation of the test mode is necessary for installing unsigned drivers, for example, developed by users, which are required to synchronize any device with a computer. But there are other reasons for this function. Re-launch the Command Line according to the instructions from the last section. Activate the first request again. Success notice displayed, then write bcdedit.exe -set TESTSIGNING ON

Activation of the Test Mode in the Command Line

When the terminal is finished, you need to restart the computer. This will confirm the change. An indicator of the success of your actions will be an inscription from below the screen, slightly above the notification area.@top-advice.ru

Rate article
TOP ADVICE
Leave a Reply